Introduction

The plastic sealing machine, also known as the plastic sealing machine, is mainly composed of driving system, heating and temperature control system, operation control board, front and rear rubber rollers, and other components. It is a specialized equipment for plastic sealing photos or documents.

Advantage

1. Overmolding machines can significantly enhance the color and contrast of photos and images;

2. Overmolding machines can prevent fingerprints, stains, or scratches on photos, images, and documents;

3. A large number of repeatedly contacted items need to be protected, such as restaurant menus;

4. Using a plastic press to store photos, documents, or documents for many years as if they were new, without fading or damaging them;

5. Overmolding machines can protect items that need to be stored outdoors for a long time;

6. Overmolding machines can prevent damage to photos, documents, or documents during transportation;

7. Photos, documents, or documents obtained from the plasticizing machine can be used underwater or under other spec

8. The strength and toughness of the documents or documents after being molded by the plastic machine have been increased.

Features

1. Can significantly enhance the color and contrast of photos and images;

2. Can prevent fingerprints, stains, or scratches on photos, images, and documents;

3. A large number of repeatedly contacted items need to be protected, such as restaurant menus;

4. Keep photos, documents, or documents as new for many years without fading or damaging them;

5. Can protect items that need to be stored outdoors for a long time;

6. It can prevent photos, documents, or documents from being damaged during transportation;

7. Photos, documents, or documents that have been molded can be used underwater or under other special conditions;

8. The documents or documents that have been molded have increased their strength and toughness.

Usage of the overmolding machine

1. Connect the power supply: After plugging in the power plug, place the glue machine switches in the "clockwise" sealing position and turn on the power switch.

2. Setting and adjusting temperature: Adjust the "temperature adjustment" knob, and then set the temperature gauge pointer of the sealing machine to around 140 ℃. Preheat until the "preheating" indicator light is on, and the sealing can begin.

3. Plastic sealing method: Clamp the photo and document to be plastic sealed between two pieces of the card film, feed it in from the front of the plastic passing machine, and the document will come out from the exit board and be taken out. Plastic sealing is completed.

4. Shutdown.